About this task
1130C Ethernet
ports 1 - 4 are 1 GbE RJ45 ports. Ensure that the device to be connected at the
other end of the segment is powered on.
To connect a twisted pair cabling:
Procedure
-
Connect the twisted pair segment
to the appliance by inserting the RJ45 connector on the twisted pair segment
into the desired RJ45 port.
-
Verify that a link exists by
checking that the Activity Link LED is On (solid green or blinking green).
If the Activity Link LED is off, perform the following steps until it is
On:
- Verify that the cabling
being used is Category 5 or better, with an impedance between 85 and 111
ohms and a maximum length of 100 meters (328 feet).
- Verify that the device at
the other end of the twisted pair segment is turned on and is properly
connected to the segment.
- Verify that the RJ45
connectors on the twisted pair segment have the proper pinouts, and
check the cable for continuity.
-
If a link is not established,
contact Extreme Networks Support.
